LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Wrangler Rubicon, Automatic Trans >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Vehicle Theft Security (Service Information) >> Sensor, Intrusion Module >> Removal >> Console

Sensor, Intrusion Module: Removal: Console

NOTE:

An intrusion sensor is installed within the center floor console only on four-door vehicles equipped with the export premium version of the Vehicle Theft Alarm (VTA).

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the center console from the vehicle. Refer to CONSOLE, CENTER, REMOVAL .
  3. Place the center console on a suitable work surface. Be certain to take the proper precautions to protect the console from receiving cosmetic damage during the service procedure.
  4. Remove the screws at each rear side of the console that secure the rear trim cover to the console.
  5. Remove the rear trim cover from the console.
  6. Remove the fasteners securing the intrusion sensor to the rear outer surface of the center console bin.
  7. Remove the intrusion sensor from the center console bin.
scientia non olet · About LEMON Manuals