LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Renegade Trailhawk >> Repair and Diagnosis >> External Pages >> Different car >> Section 263 (Audio/Video/Entertainment/Connectivity (Service Information)) >> Switch, Remote Radio >> Removal

Switch, Remote Radio: Removal

WARNING: This page is about a different car, the 2017 RAM ProMaster 3500, 2017 RAM ProMaster 2500, and 2017 RAM ProMaster 1500. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

On vehicles equipped with airbags, refer to electrical, restraints before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury.

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the driver side airbag. Refer to AIR BAG, DRIVER, REMOVAL .
    GC0160323Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the wire harness connector.
    NOTE:

    Noting the position of the wire harnesses in the steering wheel will assist during assembly. 

  4. Remove the four screws (1).
  5. Remove the remote radio switch from the steering wheel.
scientia non olet · About LEMON Manuals