LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Renegade Trailhawk >> Repair and Diagnosis >> External Pages >> Different car >> Section 253 (Ignition System (Service Information)) >> Solenoid, Variable Valve Timing >> Removal >> Left

Solenoid, Variable Valve Timing: Removal: Left

WARNING: This page is about a different car, the 2017 RAM ProMaster 3500, 2017 RAM ProMaster 2500, and 2017 RAM ProMaster 1500. However, it is still accessible from the selected car via links, so may be relevant.
GC0144208Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
    NOTE:

    Mark the Variable Valve Timing (VVT) solenoid connectors (1) with a paint pen or equivalent so that they may be reinstalled in their original locations.

  2. Mark the intake VVT solenoid (4) and the exhaust VVT solenoid (2) with a paint pen or equivalent so that they may be installed in their original locations.
  3. Disconnect the wiring harness connector (1) from the VVT solenoid.
  4. Remove the VVT solenoid mounting bolts (3).
    GC0144209Courtesy of CHRYSLER GROUP, LLC
  5. Pull the VVT solenoid from the cylinder head cover.
    NOTE:

    The seal (1) can be reused if not damaged.

scientia non olet · About LEMON Manuals