Sensor, Crankshaft Position: Installation

WARNING: This page is about a different car, the 2017 RAM ProMaster 3500, 2017 RAM ProMaster 2500, and 2017 RAM ProMaster 1500. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of CHRYSLER GROUP, LLC

CAUTION:

Before tightening the Crankshaft Position Sensor (CKP)sensor mounting bolt, be sure the sensor is completely flush to the cylinder block. If the CKP sensor is not flush, damage to the sensor mounting tang may result.

Inspect the O-ring seal (2) and replace if necessary.

Courtesy of CHRYSLER GROUP, LLC
Install the Crankshaft Position Sensor (CKP) sensor (4). Tighten bolt (3) to 11 N.m (97 in. lbs.).

Courtesy of CHRYSLER GROUP, LLC
Connect the CKP wire harness connector (3).
Install the generator. Refer to GENERATOR, INSTALLATION .
Connect the negative battery cable.