LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Renegade Limited, 4WD >> Repair and Diagnosis >> Steering >> Steering Column >> Steering System >> Column >> Removal And Installation >> Removal And Installation >> Installation

Removal And Installation: Installation

  1. Position the steering column in the vehicle. Install the four steering column to dash frame bolts, and tighten to the proper SPECIFICATIONS .
    GC0165723Courtesy of CHRYSLER GROUP, LLC
  2. Connect the two EPS wire harness connectors (2).
  3. Install and tighten the screws (1b), and the nut (1c) for the airbag support frame.
  4. Install the Data Link Connector (DLC) into the dash frame.
    GC0164823Courtesy of CHRYSLER GROUP, LLC
  5. Install the intermediate shaft (1b) to the steering gear. Tighten the intermediate shaft pinch bolt (1a) to the proper SPECIFICATIONS .
  6. Install the driver knee airbag. Refer to AIR BAG, KNEE BLOCKER, REMOVAL AND INSTALLATION .
  7. Install the sentry key antenna. Refer to ANTENNA, SENTRY KEY, REMOVAL AND INSTALLATION .
  8. Install the clockspring. Refer to CLOCKSPRING, REMOVAL AND INSTALLATION .
  9. Install the steering wheel. Refer to WHEEL, STEERING, REMOVAL AND INSTALLATION .
  10. Connect the negative battery cable.
scientia non olet · About LEMON Manuals