2.4L 1/2 Intake

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Cam Sensor

Courtesy of CHRYSLER GROUP, LLC

CAUTION:

Install camshaft position (CMP) sensor utilizing twisting motion. Make sure CMP sensor is fully seated. Do not drive CMP sensor into the bore with mounting screw. This may cause CMP sensor to be incorrectly seated causing a faulty signal or no signal at all.

Lubricate the CMP sensor O-ring seal.

Fig 2: Front Cam Sensor
Courtesy of CHRYSLER GROUP, LLC
Install the CMP sensor and mounting bolt, tighten to 9 N.m (79.5 in. lbs.).
Connect the CMP sensor wire harness connector.
Connect the negative battery cable, tighten nut to 5 N.m (45 in. lbs.).

NOTE:

The Cam/Crank Variation Relearn procedure must be performed using the scan tool anytime there has been a repair/replacement made to a powertrain system, for example: flywheel, valvetrain, camshaft and/or crankshaft sensors or components. Refer to STANDARD PROCEDURE .