Antenna, Remote Start: Removal

This show right side only. Left side similar. 

Courtesy of CHRYSLER GROUP, LLC

1. Remove the load floor. Refer to LOAD FLOOR, FOOTWELL, REMOVAL .
2. Remove the D-pillar trim. Refer to PANEL, D-PILLAR TRIM, REMOVAL .
3. Remove the rear door scuff plate. Refer to PLATE, SCUFF, LIFTGATE, REMOVAL .
4. Position the door seal (1) aside.

   Courtesy of CHRYSLER GROUP, LLC

   NOTE:

   Right side shown, left side similar.

5. Using a trim stick (special tool #C-4755, Trim Stick) or equivalent, disengage the retaining fasteners (3) that secure the quarter trim panel to the quarter panel.
6. Pull the quarter trim panel away from the quarter panel.
7. If equipped, disconnect the power outlet wire harness connector (1).
8. Remove the quarter trim panel (2).

   Courtesy of CHRYSLER GROUP, LLC

9. Disconnect the remote start antenna from the Remote Frequency Hub (RFHUB) (3).
10. Remove the fasteners securing the remote start receiver (1) to the body.
11. Remove the fasteners (3) securing the remote start antenna in place.