Diagnostic Test

DETERMINE ACTIVE DTC
NOTE:
Make sure the battery is fully charged.
1. Turn the ignition on.
2. Wait 12 seconds, then with the scan tool, read all active ORC DTCs.
  Is DTC B222D-00-ECU CONFIGURATION MISMATCH set?
  
  Yes
  - Go To 2
PERFORM THE ORC MODULE FLASH PROGRAMMING PROCEDURE
NOTE:
Make sure the battery is fully charged and the ORC part number is correct for the vehicle. Also insure the BCM is correctly programmed.

NOTE:
Service replacement ORC modules are shipped in a LOCKED OUT state and after installed will set a ORC UNLOCKED - ALL DEPLOYMENT DISABLED fault. Use a diagnostic scan tool to access the ORC module and go to the MISCELLANEOUS FUNCTIONS menu item to perform the MODULE INITIALIZATION procedure to erase the fault and initialize the new replacement ORC.
1. Perform the ORC Module Flash Programming procedure.
  Did the ORC Module flash programming procedure run 100 percent completely?
  
  Yes
  - Perform the Restraints System Verification Test. Refer to STANDARD PROCEDURE .
  No
  - Go To 3
REPEAT THE ORC MODULE FLASH PROGRAMMING PROCEDURE
1. Perform the ORC Module Flash Programming procedure.
  Did the ORC Module flash programming procedure run 100 percent completely?
  
  Yes
  - Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  
  WARNING:
  If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental airbag deployment. Failure to follow these instructions may result in possible serious or fatal injury.
  
  WARNING:
  Turn the ignition off disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
  - Replace the ORC in accordance with Service Information. Refer to MODULE, OCCUPANT RESTRAINT (ORC), REMOVAL AND INSTALLATION .
  - Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to STANDARD PROCEDURE .