Radiator, Engine Cooling: Removal: Diesel

Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
Remove the engine cover. Refer to the appropriate service information article .
Remove the battery tray. Refer to TRAY, BATTERY, REMOVAL .

Courtesy of CHRYSLER GROUP, LLC
Remove the fasteners (2, 3, 4) and the upper close out panel cover (1).
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
Remove the front fascia. Refer to FASCIA, FRONT, REMOVAL .
Drain the cooling system. Refer to STANDARD PROCEDURE .
Remove the A/C condenser. Refer to CONDENSER, A/C, REMOVAL .
Remove the Charge Air Cooler (CAC). Refer to the appropriate service information article.

Courtesy of CHRYSLER GROUP, LLC
Disconnect the cooling fan module (2) wire harness connector (1).
Disconnect the horn wire harness connector.
Remove the hood release cable from the air deflector.

Courtesy of CHRYSLER GROUP, LLC
Disconnect the ambient air temperature sensor wire harness connector (2).
Remove the left side radiator air deflector.
Remove the right side radiator air deflector.
Remove the washer reservoir. Refer to RESERVOIR, WINDSHIELD WASHER, REMOVAL .

Courtesy of CHRYSLER GROUP, LLC
Release the clip (2) and remove the right side lower radiator hose (3).

Courtesy of CHRYSLER GROUP, LLC
Remove the left side upper radiator hose (1).
Remove pushpin retainers securing wire harness and position aside wire harness.
Remove the isolators screws from the upper core support from the left and right mounting locators.
NOTE:
The radiator and cooling fan should be removed from the top by slightly rotating the components down on the right while tilting the component rearward. The left end of the component should lead out of the vehicle.
Remove the radiator from the vehicle.
Remove bolts the cooling fan assembly from radiator.