Radiator, Engine Cooling: Removal: 3.2L

Remove the engine cover.
Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
Drain the cooling system. Refer to STANDARD PROCEDURE .
Disconnect the lower radiator hose from the radiator.
Remove the hood latch. Refer to LATCH, HOOD, REMOVAL .

Courtesy of CHRYSLER GROUP, LLC
Separate the side air deflectors (2) from the upper radiator closeout panel (1).

Courtesy of CHRYSLER GROUP, LLC
Disconnect the cooling fan wire harness connector (4).
Disconnect the ambient air temperature sensor wire harness connector (5).
Disconnect the horn wire harness connectors (6).
Remove the hood release cable (3) from the air deflector.
Remove the wiring harness (7) from the air deflector.
Remove the fasteners and the upper radiator close out panel (1).

Courtesy of CHRYSLER GROUP, LLC
Disconnect the A/C pressure switch wire harness connector.
Remove the A/C fill port support bracket (2) and position aside.

Courtesy of CHRYSLER GROUP, LLC
Remove the transmission cooler line support brace bolt (1).

Courtesy of CHRYSLER GROUP, LLC
Separate the condenser from the radiator (1).

Courtesy of CHRYSLER GROUP, LLC
Remove the upper radiator hose from the upper coolant cross over pipe.
Remove the upper radiator mounts (1).

Courtesy of CHRYSLER GROUP, LLC
Disconnect the wire harness connector (1) from the cooling fan module (2).
Remove the radiator and fan assembly from the vehicle.

Courtesy of CHRYSLER GROUP, LLC
If necessary, remove the upper radiator hose (2) from the radiator.
If necessary, remove the fasteners (1) and separate radiator fan assembly from the radiator.