LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2017 >> Cherokee Trailhawk, 3.2L Eng VIN S >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Engine Cooling System >> Engine >> Radiator, Engine Cooling >> Removal >> 2.4L

Radiator, Engine Cooling: Removal: 2.4L

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the engine cover.
  3. Recover the refrigerant from the refrigerant system

    Refer to PLUMBING, STANDARD PROCEDURE .

  4. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  5. Remove the transmission skid plate, if equipped. Refer to PLATE, SKID, TRANSMISSION, REMOVAL .
  6. Remove the belly pan, if equipped. Refer to BELLY PAN, REMOVAL .
  7. Drain the cooling system. Refer to STANDARD PROCEDURE .
  8. Disconnect the quick-coupling and remove the lower coolant hose from the radiator.
    GC0159495Courtesy of CHRYSLER GROUP, LLC
  9. Separate the lower air deflector (2).
    GC0160073Courtesy of CHRYSLER GROUP, LLC
  10. Remove the push pins and remove the radiator closeout panel (1).
    GC0160015Courtesy of CHRYSLER GROUP, LLC
  11. Separate the side air deflectors (2) from the upper radiator closure panel (1).
    GC0159459Courtesy of CHRYSLER GROUP, LLC
  12. Disconnect the cooling fan module harness connector (4).
  13. Disconnect the ambient air temperature sensor harness connector (5).
  14. Disconnect the horn electrical connectors (6).
  15. Remove the hood release cable (3) from the air deflector.
  16. Remove the wiring harness (7) from the air deflector.
  17. Remove the upper air deflector (1).
    GC0159379Courtesy of CHRYSLER GROUP, LLC
  18. Loosen the clamp and remove the upper coolant hose from the radiator.
  19. Remove the transmission cooler line support bracket bolt (1).
    GC0159554Courtesy of CHRYSLER GROUP, LLC
  20. Disconnect the A/C pressure sensor harness connector (3).
  21. Remove the bolt (2) that secures the service port (1) and position aside.
    GC0162231Courtesy of CHRYSLER GROUP, LLC
  22. Remove nut and the A/C discharge (3) and liquid line (1) manifold from the condenser jumper line (2).
  23. Detach the liquid line from manifold. Remove and discard the O-ring seal and gasket.
  24. Install plugs in, or tape over the opened refrigerant line fittings and the condenser and suction line ports.
    GC0159391Courtesy of CHRYSLER GROUP, LLC
  25. Remove the upper and lower A/C condenser (1) to radiator bolts (2).
    GC0159343Courtesy of CHRYSLER GROUP, LLC
  26. Remove the bolts (2) and the upper radiator mounts (1).
    GC0162235Courtesy of CHRYSLER GROUP, LLC
  27. Disengage the jumper line junction block (1) from the radiator (2) and remove the radiator from the vehicle.
  28. Remove the cooling fan assembly from the radiator.
scientia non olet · About LEMON Manuals