Radiator, Engine Cooling: Installation: 3.2L

Courtesy of CHRYSLER GROUP, LLC

1. If removed, install the cooling fan onto the radiator. Tighten to bolts (1) to 9 N.m (80 in. lbs.).
2. If removed, install the upper radiator hose (2) onto the radiator and secure the clamp.

   Courtesy of CHRYSLER GROUP, LLC

3. Position the radiator into the lower mounting (1) isolators on the radiator lower support.

   Courtesy of CHRYSLER GROUP, LLC

4. Install the condenser to the radiator (1). Tighten the bolts (2) to 8 N.m (70 in. lbs.).

   Courtesy of CHRYSLER GROUP, LLC

5. Install and securely tighten the transmission cooler line support brace bolt (1).

   Courtesy of CHRYSLER GROUP, LLC

6. Connect the wire harness connector to the A/C pressure switch.
7. Install the A/C fill port support bracket (2) and securely tighten the fastener.

   Courtesy of CHRYSLER GROUP, LLC

8. Install the upper radiator mounts (1) and tighten bolts to 9 N.m (80 in. lbs.).
9. Install the upper radiator hose onto the upper coolant cross over pipe and secure the clamp.

   Courtesy of CHRYSLER GROUP, LLC

10. Install the upper radiator close out panel (1) and securely tighten the fasteners.
11. Install the wiring harness (7) to the air deflector.
12. Install the hood release cable (3) to the air deflector.
13. Connect the horn wire harness connectors (6).
14. Connect the cooling fan wire harness connector (4).
15. Connect the ambient air temperature sensor wire harness connector (5).

    Courtesy of CHRYSLER GROUP, LLC

16. Install the side air deflectors (2) onto the upper radiator closeout panel (1).
17. Install the hood latch. Refer to LATCH, HOOD, INSTALLATION .
18. Install the lower radiator hose.
19. Fill the cooling system. Refer to STANDARD PROCEDURE .
20. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
21. Install the engine cover.