Fan, Cooling: Removal: Gas

Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
Remove the engine cover.
Remove the belly pan. Refer to BELLY PAN, REMOVAL .

Courtesy of CHRYSLER GROUP, LLC
Remove the push pins (1) that secure the side close out deflector from the lower deflector (2).
Remove the support and lower the vehicle.

Courtesy of CHRYSLER GROUP, LLC
Remove the upper close out panel cover (1).

Courtesy of CHRYSLER GROUP, LLC
Separate the side air deflectors from the upper radiator closeout panel.

Courtesy of CHRYSLER GROUP, LLC
Disconnect the cooling fan module wire harness connector (1).

Courtesy of CHRYSLER GROUP, LLC
Disconnect the ambient air temperature sensor (5) wire harness connector.
Disconnect the horn wire harness connectors (6).
Remove the hood release cable (3) from the air deflector.
Remove the wiring harness (7) from the air deflector.
Remove the upper air deflector (1).

Courtesy of CHRYSLER GROUP, LLC
Remove the A/C fill port support bracket (2) and position aside.

Courtesy of CHRYSLER GROUP, LLC
Separate the transmission cooler line support brace bolt (1).

Courtesy of CHRYSLER GROUP, LLC
Separate the transmission cooler (2) from the condenser and position aside.

Courtesy of CHRYSLER GROUP, LLC
Separate the upper radiator hose from the radiator.
Remove the upper radiator mounts (1).

Courtesy of CHRYSLER GROUP, LLC
Remove the cooling fan module wiring harness connectors (1).
Remove the bolts that secure the cooling fan assembly to the radiator.
Using care, lift the fan slightly upward.
Tilt the cooling fan down to allow for the upper mounting tab to clear the upper radiator hose.
Remove the fan assembly from the vehicle.