2.2L Diesel

Courtesy of CHRYSLER GROUP, LLC

Guide the cooling fan (1) into position onto the radiator while clearing the upper radiator hose.
Once into position, insert the lower tabs into the retainers.
Install the bolts and tighten to the proper torque. Refer to TECHNICAL SPECIFICATIONS .
Remove the support and lower the vehicle.

Courtesy of CHRYSLER GROUP, LLC
Install a new O-ring seal (2) onto the EGR air flow control valve inlet tube (1).

Courtesy of CHRYSLER GROUP, LLC
Connect the Charge Air Cooler (CAC) hose (3) to the EGR air flow control valve inlet tube (1).
Lock the CAC tube wire retainer (2).

Courtesy of CHRYSLER GROUP, LLC
Raise and support the vehicle.
Install the nut (1) securing CAC tube (2) to engine and tighten to the proper torque. Refer to the appropriate service information article .

Courtesy of CHRYSLER GROUP, LLC
Connect the left CAC hose (1) to cooler (2).
Install the belly pan. Refer to BELLY PAN, INSTALLATION .
Remove the support and lower the vehicle.

Courtesy of CHRYSLER GROUP, LLC
Install the turbocharger inlet tube (4) and securely tighten clamps (2, 5).
Connect the Mass Air Flow (MAF) sensor wire harness connector (1) and attach the wire (3) to the inlet tube.

Courtesy of CHRYSLER GROUP, LLC
Connect the cooling fan wiring harness connector (1).
Install the engine cover. Refer to the appropriate service information article .
Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.