2.0L Diesel
- Guide the cooling fan (1) into position onto the radiator while clearing the upper radiator hose.
- Once into position, insert the lower tabs into the retainers.
- Install the bolts and tighten to the proper torque. Refer to TECHNICAL SPECIFICATIONS .
- Remove the support and lower the vehicle.
- Install a NEW
O-ring seal (2) onto the EGR air flow control valve inlet tube (1).
- Connect the Charge Air Cooler (CAC) hose (3) to the EGR air flow control valve inlet tube (1).
- Lock the CAC tube wire retainer (2).
- Raise and support the vehicle.
- Install the nut (1) securing CAC tube (2) to engine and tighten to the proper torque. Refer to TORQUE SPECIFICATIONS 3.2L
.
- Connect the left CAC hose (1) to cooler (2).
- Install the belly pan. Refer to BELLY PAN, INSTALLATION .
- Remove the support and lower the vehicle.
- Install the turbocharger inlet tube (5) and securely tighten clamps (4, 6).
- Connect the Closed Crankcase Ventilation (CCV) heater wire harness connector (4).
- Install the breather hose (2) from breather tube.
- Connect the cooling fan wiring harness connector (1).
- Install the engine cover. Refer to the appropriate service information article. .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.