LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2016 >> Wrangler Rubicon, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Vehicle Theft Security (Service Information)) >> Module, Shaft Lock >> Installation >> Installation

Module, Shaft Lock: Installation: Installation

WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Slide Tabs, Mounting Bracket & Shaft Lock Module
GC0118568Courtesy of CHRYSLER GROUP, LLC
NOTE:

Before attempting service, the ignition key must be inside the vehicle near or on the center console for the entire length of the procedure.

  1. Connect the shaft lock connector to the module.
  2. Align the engagement and slide tabs (2) on the shaft lock module housing (1) with the slots and channels in the mounting bracket (3) on the steering column.
  3. Carefully slide the module toward the top (steering wheel end) of the column until it is in mounted position and the spring clips on the module have engaged the bracket, locking it in place.
    Fig 2: Identifying Steering Column Cover Reinforcement
    GC0082691Courtesy of CHRYSLER GROUP, LLC
  4. Install the steering column cover reinforcement (1) using the four mounting screws (2).
  5. Install the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, INSTALLATION .
NOTE:

If a NEW column lock module has been installed, a new Radio Frequency Hub (RF Hub) must also be installed.

NOTE:

For module and programming order replacement. Refer to STANDARD PROCEDURE .

NOTE:

For additional information programming the ELV/ESCL. Refer to STANDARD PROCEDURE .

scientia non olet · About LEMON Manuals