LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2016 >> Renegade Trailhawk >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Engine Cooling System >> Engine >> Pump, Water >> Removal And Installation >> 2.4L Multi Air >> Installation

2.4L Multi Air: Installation

Fig 1: Water Pump Gasket
GC0169244Courtesy of CHRYSLER GROUP, LLC
  1. Install a NEW  gasket (1) onto the water pump.
    Fig 2: Water Pump & Bolts
    GC0163039Courtesy of CHRYSLER GROUP, LLC
  2. Install the water pump (1a). Tightened the five bolts (1b) in a criss-cross pattern to the proper specification. Refer to SPECIFICATIONS .
    Fig 3: Water Pump Pulley & Bolts
    GC0165695Courtesy of CHRYSLER GROUP, LLC
  3. Install the water pump pulley (1a). Tighten the three bolts (1b) to the proper specification. Refer to SPECIFICATIONS .
  4. Install the serpentine belt. Refer to BELT, SERPENTINE, REMOVAL AND INSTALLATION .
  5. Install the right front wheelhouse splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL AND INSTALLATION .
  6. Install the belly pan. Refer to BELLY PAN, REMOVAL AND INSTALLATION .
  7. Install the right front tire and wheel assembly. Refer to REMOVAL AND INSTALLATION .
  8. Fill the cooling system. Refer to STANDARD PROCEDURE .
  9. Run the engine until it reaches normal operating temperature. Check the cooling system for correct fluid level or leaks. Refer to STANDARD PROCEDURE .
  10. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals