LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2016 >> Renegade Trailhawk >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Engine Cooling System >> Engine >> Fan, Cooling >> Removal And Installation >> 2.4L Multi Air >> Installation

2.4L Multi Air: Installation

Fig 1: Cooling Fan & Brackets
GC0164973Courtesy of CHRYSLER GROUP, LLC
  1. Install the cooling fan (1b) and engage the retaining brackets (1a).
    Fig 2: Cooling Fan Wire Harness Connectors & Retainers
    GC0165167Courtesy of CHRYSLER GROUP, LLC
  2. Attach the cooler lines to the retainer and close the retainer (2b).
  3. Attach the wire harness retainer (1c) from fan shroud.
  4. Connect the cooling fan wire harness connector (1b).
  5. Connect the resistor wire harness connector (1a).
    Fig 3: Pressurized Coolant Bottle & Fasteners
    GC0165116Courtesy of CHRYSLER GROUP, LLC
  6. Install the pressurized coolant bottle (1b) and the fasteners (1a).
    Fig 4: Transmission Oil Cooler Lines & Clips
    GC0164459Courtesy of CHRYSLER GROUP, LLC
  7. Remove the plugs from the cooler lines an cooler.
  8. Connect the transmission oil cooler line (1b) and the retaining clips (1a).
    Fig 5: Exhaust Heat Shield, Nuts & Bolts
    GC0164856Courtesy of CHRYSLER GROUP, LLC
  9. Install he exhaust heat shield (1c) and securely tighten the nuts (1b) and bolts (1a).
  10. Connect the negative battery cable.
scientia non olet · About LEMON Manuals