1.6L, 2.0L: Removal

WARNING: This page is about a different car, the 2015 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.

Open the cover of the fuse box in the engine compartment and remove the fuse F21 (15 A) of the fuel pump.
Start the engine and run until the fuel in the lines is depleted.
Install the fuse removed earlier and close the fuse box cover.
Remove the rear seat cushion. Refer to SEAT CUSHION, REMOVAL AND INSTALLATION .

Fig 1: Fuel Pump Access Cover & Screws
Courtesy of CHRYSLER GROUP, LLC
Lift the cover, unscrew the screws and remove the cover to access the fuel pump (1).

Fig 2: Electrical Connection, Fuel Supply & Fuel Return Pipe Quick Coupling
Courtesy of CHRYSLER GROUP, LLC
Unplug the fuel pump's electrical connection (1).
Disconnect the fuel supply pipe quick coupling (2).
Disconnect the fuel return pipe quick coupling (3).

Fig 3: Pump Assembly Mounting Ring Set & Special Tool
Courtesy of CHRYSLER GROUP, LLC
Mount the 2000002100 (EMEA) or (special tool #9340, SAE Fuel Pump Lock Ring Wrench) (NAFTA) tool (1a) and remove the pump assembly mounting ring set (1b).

Fig 4: Fuel Pump Assembly
Courtesy of CHRYSLER GROUP, LLC
Remove the fuel pump assembly (1).

Fig 5: Tank Seal
Courtesy of CHRYSLER GROUP, LLC
Remove the seal on the tank (1).