Sensor, Intelligent Battery (IBS): Installation: Installation
WARNING: This page is about a different car, the 2014 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Connecting the negative battery cable to the Intelligent Battery Sensor (IBS) must be done before installing on the battery post.
- Place the IBS onto the negative battery post and push the IBS (3) down until properly seated on the cone of the post.
- Fasten Ground terminal to M8 (max 20Nm +/-2Nm).NOTE:
M8 has much higher torque than the M6 clamp and can break IBS free if the M6 is tightened prior.
- Secure the M6 pole clamp (max 6Nm +/- 1.5Nm).
- Install amp 2 pin connector (Power & LIN) making sure there is no stress on the wires.
- Install the components removed to access the battery. Refer to BATTERY, INSTALLATION .