Module, Electronic Limited Slip Differential: Installation: Installation

Fig 1: Electronic Limited Slip Differential Module & Connectors

Courtesy of CHRYSLER GROUP, LLC

1. Install the module in the vehicle.
2. Secure the module mounting nuts (2) and tighten to 7 N.m (5 ft. lbs.).
3. Connect the body wire harness connectors (3) to the module connector receptacle.
4. Install carpet in original position.
5. Install left rear seat. Refer to SEAT, REAR, REMOVAL .
6. Connect the negative battery cable. Refer to CABLES, BATTERY, INSTALLATION for battery location and cable connection procedure.
7. Perform the Electronic Limited Slip Differential (ELSD) verification test. Refer to STANDARD PROCEDURE .