Coil, Ignition: Installation: 3.6L

Fig 1: Ignition Coil Rubber Boot & Boot Opening

Courtesy of CHRYSLER GROUP, LLC

Using compressed air, blow out any dirt or contaminants from around the top of spark plug.
Check the condition of the ignition coil rubber boot (1). Inspect the opening of the boot (2) for any debris, tears or rips. Carefully remove any debris with a lint free cloth.

Fig 2: Uniflor 8172 Lubricant
Courtesy of CHRYSLER GROUP, LLC

CAUTION:
Do not apply a silicone based grease such as Mopar® Dielectric Grease to the ignition coil rubber boot. The silicone based grease will absorb into the boot causing it to stick and tear.
Place a small, 360° bead of Uniflor 8172 lubricant (1) along the inside opening of the coil boot approximately 1 to 2 mm from the chamfer edge but not on the chamfered surface.

Fig 3: Electrical Connector, Ignition Coils & Ignition Coil Retaining Bolts
Courtesy of CHRYSLER GROUP, LLC

NOTE:
The LH ignition coils are shown, the RH ignition coils are similar.
Install the ignition coil (2) into the cylinder head cover opening. Using a twisting action, push the ignition coil onto the spark plug. Tighten bolt(s) to the proper SPECIFICATIONS .
Connect the ignition coil wire harness connector (1) and lock connector.
If removed, install the intake manifold. Refer to MANIFOLD, INTAKE, INSTALLATION .
Install the air cleaner body. Refer to BODY, AIR CLEANER, INSTALLATION .

Fig 4: Engine Cover
Courtesy of CHRYSLER GROUP, LLC
Install the engine cover (1).
Connect the negative battery cable.