Module, Drivetrain Control: Installation: Installation

Fig 1: Identifying Drivetrain Control Module (DTCM) & Nuts

Courtesy of CHRYSLER GROUP, LLC

1. Install the DriveTrain Control Module (DTCM) (2) to the mounting studs.
2. Install the DTCM mounting nuts (1) and tighten to the proper SPECIFICATIONS .
3. Connect the DTCM wire harness connectors.
4. Install the load floor. Refer to LOAD FLOOR, CARGO, INSTALLATION .
5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
6. Perform the DTCM verification test. Refer to STANDARD PROCEDURE .