Throttle Body: Installation: 2.4L

Fig 1: New Throttle-To-Intake Manifold Gasket

Courtesy of CHRYSLER GROUP, LLC

If necessary, Install a new throttle-to-intake manifold gasket (1).

Fig 2: Throttle Body, Gasket & Bolts
Courtesy of CHRYSLER GROUP, LLC

CAUTION:
DO NOT OVER TORQUE. Over tightening can cause damage to the throttle body, gaskets, bolts and/or the intake manifold.
Install throttle body (3). Tighten four bolts (1, 2) finger tight.

Fig 3: Throttle Body Mandatory Torque
Courtesy of CHRYSLER GROUP, LLC

CAUTION:
The throttle body must be torqued in a mandatory torque sequence. Tighten in a criss - cross pattern to specification.
Tighten the bolts in criss cross pattern to the proper SPECIFICATIONS .

Fig 4: Throttle Body Support Bracket, Nut & Bolt
Courtesy of CHRYSLER GROUP, LLC
Install throttle body support bracket (2), bolt (3) and nut (1). Tighten fasteners to:
- Tighten the bracket nut (1) to the proper SPECIFICATIONS .
- Tighten the bracket bolt (3) to the proper SPECIFICATIONS .
Fig 5: Throttle Body, Retainer & Connector
Courtesy of CHRYSLER GROUP, LLC
Install wire harness retainer (3) to throttle body (2) and connect the throttle body wire harness connector (1).
Install the air cleaner resonator assembly. Refer to RESONATOR, AIR CLEANER, INSTALLATION .
Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
Use a scan tool to clear all Diagnostic Trouble Codes (DTC) and perform Electronic Throttle Control (ETC) relearn function.