Sensor, Crankshaft Position: Removal: Removal

Fig 1: Electrical Connector

Courtesy of CHRYSLER GROUP, LLC

1. Disconnect and isolate the negative battery cable.
2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
3. Disconnect the electrical connector (1) from the crankshaft position (CKP) sensor.
   Fig 2: Sensor Mounting Bolt & Sensor

   Courtesy of CHRYSLER GROUP, LLC
4. Remove the sensor mounting bolt (2).
5. Carefully twist the sensor (1) from the cylinder block.
   Fig 3: O-Ring

   Courtesy of CHRYSLER GROUP, LLC
6. The CKP sensor O-ring (1) can be reused if not damaged.