LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2015 >> Wrangler Rubicon, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Electronic Control Modules (Service Information)) >> Module, Keyless Ignition Node >> Removal >> Removal

Module, Keyless Ignition Node: Removal: Removal

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Bezel Assembly
GC0147717Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect the negative battery cable.
  2. Remove the switch-bank and bezel assembly (1). Refer to POD, SWITCH BANK, REMOVAL .
    Fig 2: Instrument Panel Center Bezel
    GC0147701Courtesy of CHRYSLER GROUP, LLC
  3. Remove the instrument panel center bezel (1). Refer to BEZEL, INSTRUMENT PANEL, CENTER, REMOVAL .
    Fig 3: Wire Connector, Clips & KIN
    GC0147718Courtesy of CHRYSLER GROUP, LLC
  4. Disconnect the wire connector (1) from the Keyless Ignition Node (KIN).
  5. Push down on the release clips (2) (two on top and one on the bottom) and push the KIN (3) out the front of the instrument panel.
scientia non olet · About LEMON Manuals