LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2015 >> Wrangler Rubicon, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Electronic Control Modules (Service Information)) >> Module, Door >> Installation >> Installation

Module, Door: Installation: Installation

WARNING: This page is about a different car, the 2016 Dodge Journey and 2015 Dodge Journey. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Door Module, Screws & Connectors
GC0139118Courtesy of CHRYSLER GROUP, LLC
  1. Position the door control module (2) to the front door hardware module carrier.
  2. Install and tighten the two screws (4) that secure the door control module to the front door hardware module carrier. Tighten the screws securely.
  3. Reconnect each of the electrical connectors (3) to the connector receptacles of the door control module.
  4. Reinstall the trim panel to the inside of the front door (1). Refer to PANEL, DOOR TRIM, INSTALLATION .
  5. Reconnect the battery negative cable.
  6. The Manual Relearn procedure should be performed following service of a door control module so that the module can learn the correct hard stops of the power window regulator. Refer to MODULE, DOOR, MODULE PROGRAMMING .
scientia non olet · About LEMON Manuals