LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2015 >> Compass Limited, FWD, Automatic Trans >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> (Transmission Control Module (TCM) - Electrical Diagnostics - 6F24 Automatic Transmission) >> Standard Procedure >> 6F24 Transmission Verification Test >> Transmission Verification Test

Transmission Verification Test

  1. Perform the following after completion of a diagnostic repair:
    1. Reconnect any disconnected components.
    2. Connect the scan tool to the Data Link Connector (DLC).
    3. With the scan tool, erase all Transmission and Engine DTCs.
    4. If the transmission or valve body has been replaced, a Clear Learned Values procedure must be performed with the scan tool.
    5. With the scan tool, display Transmission Temperature. Start and run the engine until the Transmission Temperature is HOT.
    6. Check the Transmission fluid level and adjust if necessary. Refer to the Service Information for the Fluid Fill procedure.
    7. Road test the vehicle allowing the vehicle to shift through all gears.
    8. Check for DTCs during and after the road test.

    Were there any Diagnostic Trouble Codes (DTCs) set during the road test?

    Yes 

    No 

    • Repair is complete.
scientia non olet · About LEMON Manuals