LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2015 >> Compass Limited, AWD, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Vehicle Theft Security System (Service Information)) >> SENSOR, Intrusion Module >> Removal >> Receiver

SENSOR, Intrusion Module: Removal: Receiver

WARNING: This page is about a different car, the 2009 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Intrusion Sensor Receiver
GC0080259Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the battery negative cable.
  2. Remove the overhead console from the headliner. Refer to Electrical/Overhead Console - Removal .
  3. Locate the intrusion sensor receiver (1) in the mounting bracket (4) on the right front corner of the overhead console housing (3).
  4. Disconnect the take out of the overhead wire harness from the connector receptacle (5) on the rearward end of the receiver housing.
  5. Release the three latch features (2) of the mounting bracket and disengage the receiver from the bracket.
scientia non olet · About LEMON Manuals