SENSOR, Intrusion Module: Installation: Transmitter
WARNING: This page is about a different car, the 2009 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
- Carefully pull down the right rear edge of the headliner from the upper liftgate opening far enough to reach between the headliner and the roof panel to position the intrusion sensor transmitter (2) over the locating pins of the mounting bracket (4) on the headliner substrate.
- Press the transmitter down until the two latch features (3) of the mounting bracket are fully engaged.
- Reconnect the take out of the overhead wire harness (1) to the connector receptacle on the right side of the transmitter housing.
- Reinstall the quarter trim panel onto both upper D-pillars. Refer to Body/Interior/PANEL, Quarter Trim - Installation .
- Reinstall the trim onto the upper liftgate opening. Refer to Body/Interior/PANEL, Header - Installation .
- Position the bezel (1) over the transducer housing (2) of the intrusion sensor transmitter and press it straight upward until it snaps into place against the headliner (3). Be certain to take the appropriate precautions not to soil or damage the headliner.
- Reconnect the battery negative cable.