LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2015 >> Compass Limited, AWD, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 213 (Rear Driveline Module) >> Output Flange Seal >> Installation >> Installation

Output Flange Seal: Installation: Installation

WARNING: This page is about a different car, the 2013 Jeep Patriot and 2013 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Seal Onto Installer
GC0083901Courtesy of CHRYSLER GROUP, LLC
  1. Place the seal on the installer.
    Fig 2: Install Pinion Side Seal
    GC0083902Courtesy of CHRYSLER GROUP, LLC
  2. Install the pinion side seal using Installer (special tool #9893, Installer, Seal) and Handle (special tool #C-4171, Driver Handle, Universal).
  3. Install right side halfshaft. Refer to INSTALLATION .
    Fig 3: Seal Onto Installer
    GC0083901Courtesy of CHRYSLER GROUP, LLC
  4. Place the seal on the installer.
    Fig 4: Install Ring Gear Side Seal
    GC0083903Courtesy of CHRYSLER GROUP, LLC
  5. Install the ring gear side seal using Installer (special tool #9893, Installer, Seal) and Handle (special tool #C-4171, Driver Handle, Universal).
  6. Install left side halfshaft. Refer to INSTALLATION .
  7. Fill RDA as needed. Refer to STANDARD PROCEDURE .
  8. Lower vehicle and road test.
scientia non olet · About LEMON Manuals