Diagnostic Test

WARNING: This page is about a different car, the 2012 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

CONFIGURE THE INTRUSION TRANSCEIVER MODULE
1. Using the scan tool under miscellaneous functions perform the initialization procedure for the Intrusion Transceiver Module.
2. With the scan tool, clear DTCs.
3. Turn the ignition off and remove the key from the ignition.
4. Lock and close all doors to allow the VTSS to go from pre-arm to armed status and wait one minute.
5. Disarm the VTSS.
6. Using the scan tool, read DTCs.
  Does the DTC reset?
  
  Yes
  - Replace the Intrusion Transceiver Module in accordance with the Service Information.
  - Refer to STANDARD PROCEDURE and perform the BODY VERIFICATION TEST.
  No
  - Test complete.
  - Refer to STANDARD PROCEDURE and perform the BODY VERIFICATION TEST.