Seal, Input Flange: Installation: Installation

Fig 1: Installing Pinion Seal

Courtesy of CHRYSLER GROUP, LLC

1. Coat the edge face of the seal with the liquid gasket sealer.
2. Install wave washer.
3. Install the pinion seal using Installer (special tool #9931, Installer, Seal).
   Fig 2: Electric Clutch At Rear Axle

   Courtesy of CHRYSLER GROUP, LLC
4. Install the Electronically Controlled Clutch (ECC) onto the RDA.
5. Install the mounting bolts (1) that hold the ECC to the RDA and tighten to the proper specification. Refer to SPECIFICATIONS .
6. Plug in the electrical connector (3).
7. Install the propeller shaft. Refer to INSTALLATION .
8. Fill RDA as needed. Refer to STANDARD PROCEDURE  .
9. Lower vehicle and road test.