LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2015 >> Compass Limited, AWD, Automatic Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Electronic Control Modules (Service Information) >> Module, Compass >> Removal >> Removal

Module, Compass: Removal: Removal

WARNING:

Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury. Refer to WARNING .

Fig 1: Identifying Remote Compass Module (RCM), Instrument Panel, Screws & Electrical Connector
GC0098553Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the battery negative cable.
  2. Remove the instrument panel top cover. Refer to COVER, INSTRUMENT PANEL, REMOVAL .
  3. Remove the screws (3) securing the Remote Compass Module (RCM) (1) to the instrument panel (2).
  4. Disconnect the electrical connector (4) and remove the RCM from the vehicle.
scientia non olet · About LEMON Manuals