Fuel Level Sending Unit And Sensor: Installation: Installation

WARNING: This page is about a different car, the 2013 Jeep Patriot and 2013 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Resistor Card

Courtesy of CHRYSLER GROUP, LLC

CAUTION:

Do not touch the terminals or the resistor card.

CAUTION:

Do not handle the new fuel level sending unit by the float arm.

Position the new fuel level sending unit to the fuel pump module reservoir.

Fig 2: Pushing Fuel Level Sending Unit Down Until Snap Tab Engages
Courtesy of CHRYSLER GROUP, LLC
Gently push the fuel level sending unit down until the snap tab (2) engages.

Fig 3: Fuel Level Sending Unit Electrical Connector
Courtesy of CHRYSLER GROUP, LLC

CAUTION:
Ensure the fuel level sending unit wires are routed so they do not get pinched between the coils of the spring when the module is completely compressed.
Connect the fuel level sending unit electrical connector.
Install the fuel pump module. Refer to (AWD) MODULE, FUEL PUMP, INSTALLATION (FWD) MODULE, FUEL PUMP, INSTALLATION .