2.2L Diesel

Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
Remove the engine cover. Refer to

Fig 1: Cooling Fan Module & Harness Connector
Courtesy of CHRYSLER GROUP, LLC
Disconnect the cooling fan module harness connector (1).

Fig 2: Mass Air Flow (MAF) Sensor Wire Harness Connector, Wire Harness Clamps & Air Cleaner Outlet Tube
Courtesy of CHRYSLER GROUP, LLC
Disconnect the Mass Air Flow (MAF) sensor wire harness connector (1) and detach the wire (3) from inlet tube.
Loosen clamps (1, 5) and remove the turbocharger inlet tube (4).
Remove the bolts that secure the cooling fan assembly to the radiator.
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
Remove the belly pan. Refer to BELLY PAN, REMOVAL .

Fig 3: Left Charge Air Cooler (CAC) & Hose
Courtesy of CHRYSLER GROUP, LLC
Disconnect the left Charge Air Cooler (CAC) hose (1) from cooler (2).

Fig 4: CAC Tube-To-Engine Nut
Courtesy of CHRYSLER GROUP, LLC
Remove nut (1) securing CAC tube (2) to engine.
Remove the support and lower the vehicle.

Fig 5: EGR Air Flow Control Valve Inlet Tube, CAC Tube Wire Retainer & CAC Hose
Courtesy of CHRYSLER GROUP, LLC
Unlock CAC tube wire retainer (2).
Separate the CAC hose (3) at from EGR air flow control valve inlet tube (1).
Raise and support the vehicle.
Using care, lift the fan slightly upward.

Fig 6: Cooling Fan Assembly
Courtesy of CHRYSLER GROUP, LLC
Tilt the cooling fan down to allow for the upper mounting tab to clear the upper radiator hose.
Remove the cooling fan assembly from the vehicle.