LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2015 >> Cherokee Limited, 3.2L Eng VIN S, AWD, Automatic T/Case Control >> Repair and Diagnosis >> Engine Mechanical >> Exhaust System >> Sensor, Exhaust Temperature >> Installation >> 2.2L Diesel EGT Sensor 1/1

2.2L Diesel EGT Sensor 1/1

Fig 1: EGT Sensor 1/1 & Exhaust Manifold
GC0170040Courtesy of CHRYSLER GROUP, LLC
  1. Install the Exhaust Gas Temperature (EGT) sensor 1/1 (1) into the exhaust manifold (2) and tighten to the proper specification. Refer to SPECIFICATIONS .
    Fig 2: Right Side CAC Tube, Exhaust Manifold Exhaust Gas Temperature Sensor Wire & Bolt
    GC0170012Courtesy of CHRYSLER GROUP, LLC
  2. Attach the EGT sensor 1/1 wire harness (3) to the Charge Air Cooler (CAC) inlet tube (2).
    Fig 3: EGT Sensor Connectors
    GC0169912Courtesy of CHRYSLER GROUP, LLC
  3. Connect the EGT sensor wire harness connector (2).
  4. Remove the support and lower the vehicle.
  5. Install the engine cover.
  6. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
scientia non olet · About LEMON Manuals