LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2015 >> Cherokee Limited, 3.2L Eng VIN S, AWD, Automatic T/Case Control >> Repair and Diagnosis >> Engine Mechanical >> Exhaust System >> Sensor, Exhaust Temperature >> Installation >> 2.0L EGT Sensor 1/1

2.0L EGT Sensor 1/1

Fig 1: Upstream Exhaust Temperature Sensor, Wire, Bracket & Connector
GC0153964Courtesy of CHRYSLER GROUP, LLC
  1. Install the Exhaust Gas Temperature sensor 1/1 (5) and tighten to the proper specification. Refer to SPECIFICATIONS .
  2. Attach the EGT sensor 1/1 wire harness connector (3) to bracket (4).
  3. Attach the EGT sensor 1/1 wire (1) to heat shield (2).
    Fig 2: Upstream Exhaust Temperature Sensor Connector
    GC0153959Courtesy of CHRYSLER GROUP, LLC
  4. Connect the EGT sensor wire harness connector (1).
    Fig 3: Engine Cover
    GC0157479Courtesy of CHRYSLER GROUP, LLC
  5. Install the engine cover (1).
  6. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
scientia non olet · About LEMON Manuals