LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2015 >> Cherokee Limited, 3.2L Eng VIN S, AWD, Automatic T/Case Control >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Electronic Control Modules (Service Information) >> Module, Keyless Ignition Node >> Installation >> Installation

Module, Keyless Ignition Node: Installation: Installation

  1. Connect the wire harness to the keyless ignition node.
  2. Secure the keyless ignition node and bracket to the instrument panel.
  3. Install the HVAC control panel.
  4. Install the center dash trim bezel.
  5. Install the lower steering column opening trim panel. Refer to COVER, STEERING COLUMN OPENING, INSTALLATION .
  6. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
  7. If the KIN is being replaced, perform the verification test. Refer to STANDARD PROCEDURE .
    NOTE:

    This procedure will require you to log into DealerCONNECT and enter a PIN when requested. The PIN is temporary and will be active for 12 hours. After 12 hours, a new PIN will need to be obtained from DealerCONNECT. 

scientia non olet · About LEMON Manuals