LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Wrangler Rubicon, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 203 (Engine Cooling System) >> Engine >> Sensor, Coolant Temperature >> Installation >> 3.0L/3.6L

Sensor, Coolant Temperature: Installation: 3.0L/3.6L

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: ECT Sensor & Connector
GC0169778Courtesy of CHRYSLER GROUP, LLC
  1. Install Engine Coolant Temperature (ECT) sensor (2) into cylinder head and tighten to the proper SPECIFICATIONS .
  2. Connect electrical connector (1).
  3. Install the drivers side front inner wheel splash shield. Refer to SHIELD, SPLASH, WHEELHOUSE, INSTALLATION .
  4. Lower vehicle.
  5. Connect the negative battery cable.
  6. Fill cooling system. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals