Repair Procedure - WITECH™ Diagnostic Application
WARNING: This page is about a different variant/trim than selected.
NOTE:
If this flash process is interrupted or aborted, the flash should be restarted.
- Open the hood of the vehicle and install a battery charger. Verify that the charging rate provides a continuous charge of 13.2 - 13.5 Volts.
- Connect the wiTECH™ Vehicle Connection Interface (VCI) pod to the vehicle data link connector located under the steering column and turn the ignition key to the "RUN" position.
- Launch the wiTECH™ Diagnostic Application and connect to the appropriate wiTECH™ device.
- From the wiTECH™ Diagnostic Application Home screen,
- Select "HELP"
- Select "HELP CONTENTS"
- Follow the "HELP TOPIC" for flashing an ECU.