LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Compass Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 258 ((Transmission Control Module (TCM) - Electrical Diagnostics - Continuously Variable Transmission (CVT))) >> DTC Troubleshooting >> P0717-Input Speed Sensor 1 Circuit No Signal >> Set Condition

Set Condition

WARNING: This page is about a different car, the 2013 Jeep Patriot and 2013 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.

Condition one:  Input speed rpm is less than 150 rpm with a Output speed rpm greater than 1000 rpm for the period of 5 seconds.

Condition two:  Input speed rpm last value is greater than 1000 rpm where as the Input speed rpm current value is zero rpm for the period of 500 msec.

Condition three:  Both the Input and Output Speed sensors are less than 150 rpm with a actual vehicle speed greater than 10 Km/h. (Note: this is an indication of either the power supply to both sensors is open or the C106 connector is disconnected.)

scientia non olet · About LEMON Manuals