LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Compass Limited, AWD, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Charging System (Service Information)) >> Generator >> Installation >> 2.8L Diesel

2.8L Diesel

WARNING: This page is about a different car, the 2009 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: GENERATOR - 2.8L DIESEL
GC0085945Courtesy of CHRYSLER LLC
  1. Position generator (1) to engine and install four mounting bolts (2). Tighten all four bolts to 54 N.m (40 ft. lbs.).
  2. Snap field wire connector into rear of generator.
  3. Install B+ terminal and nut to generator mounting stud. Tighten nut to 13 N.m (115 in. lbs.)
  4. Snap plastic protective cover to B+ terminal.
    CAUTION: Never force a belt over a pulley rim using a screwdriver. The synthetic fiber of the belt can be damaged.
    CAUTION: When installing a serpentine accessory drive belt, the belt MUST be routed correctly. The water pump will be rotating in the wrong direction if the belt is installed incorrectly, causing the engine to overheat. Refer to belt routing label in engine compartment, or refer to Belt Schematics in Cooling System.
  5. Install drive belt. Refer to COOLING for belt routing, belt adjustment and bolt tightening procedures.
  6. Install negative battery cable to battery.
scientia non olet · About LEMON Manuals