LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Compass Limited, AWD, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 223 (Fuel System) >> Fuel Injection, Diesel >> Fuel Injector(S) >> Removal >> Removal

Fuel Injector(S): Removal: Removal

WARNING: This page is about a different car, the 2013 Jeep Patriot and 2013 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Engine Cover
GC0137871Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect the negative battery cable.
  2. Remove the engine cover (1).
    Fig 2: Camshaft Position Sensor (CMP) Harness Connector & Fuel Injector Harness Connectors
    GC0137894Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the Camshaft Position Sensor (CMP) (1) wire harness connector.
  4. Disconnect the fuel injector wire harness connector (2).
  5. Lift up on fuel injector wire harness and position aside.
    Fig 3: Turbocharger Actuator Harness Connector
    GC0137895Courtesy of CHRYSLER GROUP, LLC
  6. Disconnect the turbocharger actuator (1) wire harness connector.
  7. Remove the air cleaner body. .
    Fig 4: Turbocharger Exhaust Temperature Sensor Harness Connector
    GC0137896Courtesy of CHRYSLER GROUP, LLC
  8. Disconnect the turbocharger exhaust temperature sensor (1) wire harness connector.
    Fig 5: Glow Plug Module Harness Connector, Bolts & Turbocharger Exhaust Temperature Sensor Harness Connector
    GC0137897Courtesy of CHRYSLER GROUP, LLC
  9. Disconnect the turbocharger exhaust temperature sensor wire harness connector (2) from bracket.
  10. Remove the two bolts (3) and position aside the ground wires.
  11. Disconnect the glow plug module wire harness connector (1).
    Fig 6: Lock Tabs & Engine Wire Harness
    GC0137898Courtesy of CHRYSLER GROUP, LLC
  12. Disconnect the fuel rail pressure sensor wire harness connector.
  13. Release the four lock tabs (1) position aside engine wire harness.
    Fig 7: Releasing Lock Tab
    GC0137899Courtesy of CHRYSLER GROUP, LLC
  14. Release the lock tab (1) and disconnect the fuel injector return line from each fuel injector and position aside.
    Fig 8: Fuel Injectors, High Pressure Fuel Tubes, Fuel Rail & High Pressure Feed Line
    GC0137901Courtesy of CHRYSLER GROUP, LLC
  15. Remove high pressure fuel tubes (2) at fuel injectors (1) and fuel rail (3) and discard high pressure fuel tubes.
  16. Install protective caps onto the fuel injector and fuel rail.
    Fig 9: Bolt & Clamping Claw
    GC0137902Courtesy of CHRYSLER GROUP, LLC
  17. Remove bolt (1) and fuel injector clamping claw (2).
    Fig 10: Removing Fuel Injector
    GC0138079Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Mark the location of each injector being removed.

  18. Using Slide Hammer (special tool #8941, Puller) (1) and Extraction Claw (special tool #10238, Claw, Extraction) (2), remove the fuel injector (3).
scientia non olet · About LEMON Manuals