Input Flange Seal: Installation: Installation
WARNING: This page is about a different car, the 2013 Jeep Patriot and 2013 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
- Coat the edge face of the seal with the liquid gasket sealer.
- Install wave washer.
- Install the pinion seal using Installer (special tool #9931, Installer, Seal).
- Install the ECC onto the RDA.
- Install the mounting bolts (1) that hold the ECC to the RDA and Tighten to 78 N.m (58 ft. lbs.).
- Plug in the electrical connector (3).
- Install the propeller shaft. Refer to INSTALLATION .
- Fill RDA as needed. Refer to STANDARD PROCEDURE - DRAIN AND FILL .
- Lower vehicle and road test.