LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2014 >> Compass Limited, AWD, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 147 (Electronic Control Modules (Service Information)) >> Module, Powertrain Control, 2.8L Diesel >> Removal >> Removal

Module, Powertrain Control, 2.8L Diesel: Removal: Removal

WARNING: This page is about a different car, the 2012 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Engine Control Module - Diesel
GC0100785Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Remove the glow plug relay from the powertrain control module mounting bracket (3) and position the relay aside.
  3. Disconnect the positive battery cable from the Totally Integrated Power Module (TIPM), remove the TIPM from the mounting bracket and position the TIPM aside. Refer to MODULE, TOTALLY INTEGRATED POWER (TIPM), REMOVAL .
  4. Disconnect the two harness connectors (1) from the powertrain control module (4).
  5. Remove the two nuts or screws (5) that secure the powertrain control module bracket to the fender (2).
  6. Remove the powertrain control module and bracket as an assembly from the vehicle.
  7. If required, remove the powertrain control module from the bracket.
scientia non olet · About LEMON Manuals