Coil, Ignition: Removal: 3.2L

Fig 1: Engine Cover & Ball Studs

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate the negative battery cable.
Lift the engine cover from the retaining grommets off of the ball studs (2) and remove the engine cover (1).
If removing the ignition coils from cylinders 1, 3 or 5 on the right side of the engine. Remove the air intake resonator. Refer to RESONATOR, AIR CLEANER, REMOVAL .
If removing the ignition coils from cylinders 2, 4 or 6 on the left side of the engine. Remove the upper intake manifold and insulator. Refer to MANIFOLD, INTAKE, REMOVAL .

Fig 2: Electrical Connector, Ignition Coils & Ignition Coil Retaining Bolts
Courtesy of CHRYSLER GROUP, LLC

NOTE:
The left side ignition coils are shown in illustration, the right side ignition coils are similar.
Disconnect the harness connector (1) from the ignition coil (2).
Remove the ignition coil retaining bolt (3).
Pull the ignition coil (2) from cylinder head cover opening with a slight twisting action.