Sensor, Crankshaft Position: Removal: 3.2L

The crankshaft position (CKP) sensor is mounted into the right rear side of the cylinder block.

1. Disconnect and isolate the negative battery cable.
2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
3. If equipped with AWD, remove the PTU (1). Refer to REMOVAL .
   Fig 1: Crankshaft Position Sensor Electrical Connector

   Courtesy of CHRYSLER GROUP, LLC
4. Disconnect the electrical connector (1) from the crankshaft position (CKP) sensor.
   Fig 2: Sensor Mounting Bolt & Sensor

   Courtesy of CHRYSLER GROUP, LLC
5. Remove the sensor mounting bolt (2).
6. Carefully twist the sensor (1) from the cylinder block.
   Fig 3: O-Ring

   Courtesy of CHRYSLER GROUP, LLC
7. The CKP sensor O-ring (1) can be reused if not damaged.