Sensor, Oxygen: Removal: Front: Notes

Fig 1: Up Stream Oxygen Sensor & Electrical Connectors

Courtesy of CHRYSLER GROUP, LLC

The engine is equipped with four heated oxygen sensors:

WARNING:

The exhaust pipes and catalytic converter become very hot during engine operation. Allow the engine to cool before removing the oxygen sensor.

Disconnect and isolate the negative battery cable.
CAUTION:
When disconnecting the oxygen sensor electrical connector, do not pull directly on the wire going into the sensor. The sensor wiring can be damaged resulting in sensor failure.
Disconnect the heated oxygen sensor electrical connectors (1).
Remove the up stream oxygen sensor (2).
Raise the vehicle.

Fig 2: Removing/Installing Belly Pans
Courtesy of CHRYSLER GROUP, LLC
Remove the belly pan (1).

Fig 3: Oxygen Sensors, Harness Connectors & Catalytic Converter
Courtesy of CHRYSLER GROUP, LLC
Disconnect the heated oxygen sensor electrical connector (3).
Remove the down stream O2 sensor (3).
Clean the exhaust pipe threads using an appropriate tap.