Exhaust Temperature Sensor 1/1

Fig 1: Exhaust Manifold, Gaskets, Turbocharger, Cylinder Head & Fasteners

Courtesy of CHRYSLER GROUP, LLC

CAUTION:

The exhaust gas temperature sensor requires care when handling and installing. The exhaust gas temperature sensor is sensitive to knocks and bending. For this reason if the exhaust gas temperature sensor has been dropped, it must not be installed as damage to the sensor may have occurred. Do not remove from packaging until ready to install. Failure to follow these instructions may result in damage to the exhaust gas temperature sensor.

Install the exhaust temperature sensor (7) and tighten to 45 N.m (33 ft. lbs.).

Fig 2: Diesel Particulate Filter Clamp
Courtesy of CHRYSLER GROUP, LLC
Align the Diesel Particulate Filter (DPF) pipe to the turbocharger. Tighten the clamp (2) to 25 N.m (18 ft. lbs.)

Fig 3: Oxygen Sensor Connector & Ball Stud Fastener
Courtesy of CHRYSLER GROUP, LLC
Connect the upstream exhaust temperature sensor wire harness connector.
Connect the oxygen sensor wire harness connector (1).

Fig 4: Two Nuts, Air Inlet Duct & Dash Panel
Courtesy of CHRYSLER GROUP, LLC
Install the HVAC air inlet housing (1) and securely tighten nuts.

Fig 5: Cowl Extension Silencer, Side Extensions & Fasteners
Courtesy of CHRYSLER GROUP, LLC
Install the cowl extension silencer. Refer to SILENCER, COWL EXTENSION, INSTALLATION .

Fig 6: Engine Cover
Courtesy of CHRYSLER GROUP, LLC
Install the engine cover (1).
Connect the negative battery cable.